Generic activity A-10.

Intergranular stress corrosion cracking leading to steam generator tube failure.
Published: (1984)

Implementation of NUREG-0313, technical report on material selection & processing GL for BWR coolant press boundary piping.
Published: (1981)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1981)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1981)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1985)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1981)

BWR feedwater nozzle and control rod drive return line nozzle cracking (NUREG-0619).
Published: (1981)

Potential for stress corrosion cracking in steam generator tube plugs supplied by Babcock and Wilcox.
Published: (1989)

Undetected installation errors in main steam line pipe tunnel differential temperature-sensing elements at boiling water reactors.
Published: (1989)

NRC position on IGSCC in BWR austenitic stainless steel piping.
Published: (1988)

Core shroud cracking at beltline region welds in boiling-water reactors.
Published: (1993)

Cracking in the lower region of the core shroud in boiling water reactors.
Published: (1994)

Crack growth rates of irradiated austenitic stainless steel weld heat affected zone in BWR environments /
Published: (2006)

Failure of a boiling water reactor target rock main steam safety/relief valve.
Published: (2003)

Assessment and management of ageing of major nuclear power plant components important to safety : BWR pressure vessels.
Published: (2005)

Pipe cracking in U.S. BWRs : a regulatory history /
by: Strosnider Jr., J. R.
Published: (2000)

Anomalous behavior of recirculation loop plow in jet pump BWR plants.
Published: (1986)

Boiling water reactor safety/relief valve failures.
Published: (1983)

Cracking in boiling-water-reactor Mark I and Mark II containments caused by failure of the inerting system.
Published: (1985)

Service degradation of thick wall stainless steel recirculation system piping at a BWR plant.
Published: (1982)

Cracking in main steam lines.
Published: (1981)

Hydrogen combustion events in foreign BWR piping.
Published: (2002)

Inspections of BWR stainless steel piping.
Published: (1984)

Technical resolution of Generic Issue No. B-59-(N-1) loop operation in BWRs and PWRs.
Published: (1986)

Resolution of generic issue 101 "Boiling water reactor water level redundancy".
Published: (1989)

Procedural guidance for pipe replacement at BWRS.
Published: (1984)

Failure of steam dryer cover plate after a recent power uprate.
Published: (2002)

Cracking of valves in the condensate return lines of a BWR emergency condensation system.
Published: (1992)

Higher than predicted erosion/corrosion in unisolable reactor coolant pressure boundary coolant inside containment at a boiling water reactor.
Published: (1992)

Degraded ability to isolate the reactor coolant system from low-pressure coolant systems in BWRS.
Published: (1986)

Failures to identify containment leakage due to inadequate local testing of BWR vacuum relief system valves.
Published: (1986)

TRACE (V 5.0 Patch 2) validation based on the RELAP5-Calculation of FIX-III LOCA experiments no. 5052, 4011, 3051 /
by: Sheng, S. ChunHong
Published: (2014)

Failures of scram discharge volume vent and drain valves.
Published: (1986)

Circumferential cracking of steam generator tubes.
Published: (1995)

An experimental and modelling study of natural-circulation boiling water reactor dynamics /
by: Zboray, Robert
Published: (2002)

Technical resolution of Generic Issue B-19-thermal hydraulic stability.
Published: (1985)