Degradation of containment isolation capability by a high-energy line break.

Availability of NUREG-1169, "Technical findings related to Generic Issue C-8; boiling water reactor main steam isolation valve leakage and leakage treatment methods".
Published: (1986)

Inadvertent containment spray due to personnel error.
Published: (1981)

Containment purging and venting during normal operation.
Published: (1979)

Direction-dependent leak characteristics of containment purge valves.
Published: (1988)

Containment purging and venting during normal operation--guidelines for valve operability.
Published: (1979)

Intergranular stress corrosion cracking leading to steam generator tube failure.
Published: (1984)

IGSCC in BWR plants.
Published: (1984)

Stress corrosion cracking in PWR steam generator tubes.
Published: (1990)

Circumferential cracking of steam generator tubes.
Published: (1995)

Potential for stress corrosion cracking in steam generator tube plugs supplied by Babcock and Wilcox.
Published: (1989)

Shield building concrete subsurface laminar cracking caused by moisture intrusion and freezing.
Published: (2013)

Crack in weld area of reactor coolant system hot leg piping at V.C. Summer.
Published: (2000)

Supplemental information to Generic Letter 95-03 "Circumferential cracking of steam generator tubes".
Published: (1995)

Failure of swing check valve in the decay heat removal system at Davis-Besse Unit No. 1.
Published: (1980)

Fatigue crack flaw tolerance in nuclear power plant piping : a basis for improvements to ASME code section XI Appendix L /
Published: (2007)

Susceptibility of containment sump recirculation gate valves to pressure locking.
Published: (1995)

Design of the reactor containment systems in nuclear power plants : a safety guide.
Published: (1985)

Excessive nitrogen supply pressure actuates safety-relief valve operation to cause reactor depressurization.
Published: (1980)

Cracks in stiffening rings on 48-Inch-diameter UF6 cylinders.
Published: (1987)

Unisolable crack in high-pressure injection piping.
Published: (1997)

Assessment of eddy current testing for the detection of cracks in cast stainless steel reactor piping components /
Published: (2007)

Axial (longitudinal) oriented cracking in piping.
Published: (1980)

Potential loss of redundant safety-related equipment because of the lack of high-energy line break barriers.
Published: (2000)

Cracking of vertical welds in the core shroud and degraded repair.
Published: (1997)

Failure to close service water cross-connect isolation valves.
Published: (1989)

RHR valve misalignment causes degradation of ECCS in PWRS.
Published: (1987)

Unit startup with degraded high pressure safety injection system.
Published: (1986)

LWR primary coolant system pressure isolation valves.
Published: (1980)

Valve stem corrosion failures.
Published: (1985)

Resolution of Generic Safety Issue 188 : steam generator tube leaks or ruptures concurrent with containment bypass from main steam line or feedwater line breaches /
by: Reichelt, E.
Published: (2009)

Potential degradation of secondary containment.
Published: (1990)

Isolation of reactor coolant system from low-pressure systems outside containment.
Published: (1984)

Degraded ability to isolate the reactor coolant system from low-pressure coolant systems in BWRS.
Published: (1986)

Steel containment degradation and associated license renewal aging management issues.
Published: (2011)

Cavitation erosion of letdown line orifices resulting in fatigue cracking of pipe welds.
Published: (1998)

Leaking shutdown cooling isolation valves at Cooper Nuclear Station.
Published: (1994)