IGSCC in BWR plants.

Anomalous behavior of recirculation loop plow in jet pump BWR plants.
Published: (1986)

Inspections of BWR stainless steel piping.
Published: (1984)

Service degradation of thick wall stainless steel recirculation system piping at a BWR plant.
Published: (1982)

Stress corrosion cracking in PWR steam generator tubes.
Published: (1990)

Higher than predicted erosion/corrosion in unisolable reactor coolant pressure boundary coolant inside containment at a boiling water reactor.
Published: (1992)

Cracking of valves in the condensate return lines of a BWR emergency condensation system.
Published: (1992)

Failure of a boiling water reactor target rock main steam safety/relief valve.
Published: (2003)

Generic activity A-10 BWR cracks.
Published: (1980)

Failures to identify containment leakage due to inadequate local testing of BWR vacuum relief system valves.
Published: (1986)

Boiling water reactor safety/relief valve failures.
Published: (1983)

Intergranular stress corrosion cracking of core shrouds in boiling water reactors.
Published: (1994)

Valve stem corrosion failures.
Published: (1985)

Cracking in main steam lines.
Published: (1981)

Circumferential cracking of steam generator tubes.
Published: (1995)

Procedural guidance for pipe replacement at BWRS.
Published: (1984)

Fatigue crack flaw tolerance in nuclear power plant piping : a basis for improvements to ASME code section XI Appendix L /
Published: (2007)

Degradation of containment isolation capability by a high-energy line break.
Published: (1989)

Failures of scram discharge volume vent and drain valves.
Published: (1986)

Degraded ability to isolate the reactor coolant system from low-pressure coolant systems in BWRS.
Published: (1986)

Contaminants and stagnant conditions affecting stress corrosion cracking in stainless steel piping in pressurized water reactors.
Published: (2011)

Failure of safety/relief valves to open at BWR--final report.
Published: (1983)

Assessment and management of ageing of major nuclear power plant components important to safety : BWR pressure vessels.
Published: (2005)

Supplemental information to Generic Letter 95-03 "Circumferential cracking of steam generator tubes".
Published: (1995)

Uncontrolled leakage of reactor coolant outside containment.
Published: (1985)

Generic activity A-10.
Published: (1980)

Hydrogen combustion events in foreign BWR piping.
Published: (2002)

Stress corrosion cracking in nonsensitized 316 stainless steel.
Published: (1984)

Assessment of eddy current testing for the detection of cracks in cast stainless steel reactor piping components /
Published: (2007)

Axial (longitudinal) oriented cracking in piping.
Published: (1980)

Failure of condensate piping because of erosion-corrosion at a flow-straightening device.
Published: (1995)

Water chemistry and corrosion of nuclear power plant structural materials /
by: Kritsky, V. G.
Published: (1999)

Cracks in stiffening rings on 48-Inch-diameter UF6 cylinders.
Published: (1987)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1981)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1981)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1981)

Safety concerns associated with pipe breaks in the BWR scram system.
Published: (1985)