Degradation of automatic ECCS actuation capability by isolation of instrument lines.

Effect of a DC power supply failure on ECCS performances.
Published: (1980)

Inadvertent loss of capability for emergency core cooling system motors.
Published: (1997)

Potentially inadequate performance of ECCS in PWRs during recirculation operation following a LOCA.
Published: (1988)

Potential for loss of minimum flow paths leading to ECCS pump damage during a LOCA.
Published: (1985)

Foreign material found in the emergency core cooling system.
Published: (2006)

Knowledge base for the effect of debris on pressurized water reactor emergency core cooling sump performance /
Published: (2003)

Design deficiencies can lead to reduced ECCS pump net positive suction head during design-basis accidents.
Published: (1998)

Potential failure of BWR backup manual scram capability.
Published: (1980)

Realistic emergency core cooling system evaluation model effects resulting from nuclear fuel thermal conductivity degradation.
Published: (2011)

Incorrect unreviewed safety question determination related to emergency core cooling system swapover from the injection mode to the recirculation mode.
Published: (1997)

HPCI/RCIC high steam flow setpoints.
Published: (1982)

Managing gas accumulation in emergency core cooling, decay heat removal, and containment spray systems.
Published: (2008)

Failure to consider loss of DC bus in the emergency core cooling system evaluation may lead to nonconservative analysis.
Published: (1993)

Analysis of semiscale test S-LH-1 using RELAP5/MOD2 /
by: Hall, P. C. (Peter C.), et al.
Published: (1992)

Cracking in the lower region of the core shroud in boiling water reactors.
Published: (1994)

Potential common cause vulnerabilities in essential service water systems.
Published: (2007)

Reactor vessel top guide and core plate cracking.
Published: (1995)

RELAP/MOD3 analysis of BETHSY test 6.9c : loss of RHRS: SG manway open /
by: Kimber, G. R.
Published: (2000)

Characterization and head-loss testing of latent debris from pressurized-water-reactor containment buildings /
Published: (2005)

Degaded throttle valves in emergency core cooling system resulting from cavitation-induced erosion during a loss-of-coolant accident.
Published: (1997)

Hydraulic transport of coating debris : a subtask of GSI-191 /
Published: (2006)

Potential common cause vulnerabilities in essential service water systems due to inadequate chemistry controls.
Published: (2007)

Recent operating experience of service water systems due to external conditions.
Published: (2006)

Operating experience regarding entrainment of air into emergency core cooling and containment spray systems.
Published: (2006)

Screen penetration test report /
by: Maji, A.
Published: (2005)

Actuators : basics and applications /
Published: (2004)

Potential clogging of high pressure safety injection throttle valves during recirculation.
Published: (1996)

Effects of insulation debris on throttle-valve flow performance : a subtask of GSI-191 /
Published: (2006)

Assessment of RELAP5/MOD3/V5m5 against the UPTF test no. 11 (countercurrent flow in PWR hot leg) /
by: Curca-Tivig, F.
Published: (1993)

Emergency net positive suction head of emergency core cooling and containment heat removal pumps under design basis accident conditions.
Published: (1996)

Pneumatic actuating systems for automatic equipment : structure and design /
by: Krivts, Igor Lazar
Published: (2006)

Actuators update /
Published: (1988)

Sensors and actuators : control systems instrumentation /
by: De Silva, Clarence W.
Published: (2007)

Handbook of valves and actuators /
Published: (2007)

Assurance of sufficient net positive suction head for emergency core cooling and containment heat removal pumps.
Published: (1997)

Sensors, Actuators, and Their Interfaces : A multidisciplinary introduction /
by: Ida, Nathan
Published: (2020)