Cover Image

Design of centrifugal impeller blades.

Bibliographic Details
Corporate Author:	United States. National Advisory Committee for Aeronautics
Format:	Government Document eBook
Language:	English
Published:	[Washington] : [s.n.], 1939.
Subjects:	Airplanes. Aeronautics > Research. Mathematical models.
Online Access:	Electronic resource (PDF)

Similar Items

An analysis of longitudinal stability in power-off flight with charts for use in design.
Published: (1935)

Methods and formulas for calculating the strength of plate and shell constructions as used in airplane design.
Published: (1936)

Ice formation on wings.
Published: (1939)

Torsional stability of aluminum alloy seamless tubing.
Published: (1939)

Theory of two-dimensional potential flow about arbitrary wing sections.
Published: (1939)

Comparison of theory with experiment in phenomenom of wing flutter.
Published: (1939)

A method of estimating the critical buckling load for structural members.
Published: (1939)

Theory of automatic control of airplanes.
Published: (1939)

Theoretical study of various airplane motions after initial disturbance.
Published: (1938)

Potential flow about arbitrary biplane wing sections.
Published: (1935)

Considerations affecting the additional weight required in mass balance of ailerons.
Published: (1937)

Compression struts with nonprogressively variable moment of inertia.
Published: (1938)

Motion of the two-control airplane in rectilinear flight after initial disturbances with introduction of controls following an exponential law.
Published: (1937)

Calculation of load distribution in stiffened cylindrical shells.
Published: (1938)

Study of torque equilibrium of autogiro rotor.
Published: (1938)

Behavior of plate strip under shear and compressive stresses beyond buckling limit.
Published: (1938)

The impact on floats or hulls during landing as affected by bottom width.
Published: (1936)

Analysis of 3 lowest bending frequencies of rotating propeller.
Published: (1936)

On the determination of the take℗--off characteristics of a seaplane.
Published: (1938)

Behavior of static pressure heads at high speeds.
Published: (1938)

Operational treatment of nonuniform-lift theory in airplane dynamics.
Published: (1938)

Investigations on the amount of downwash behind rectangular and elliptical wings.
Published: (1936)

Experimental studies of the effective width of buckled sheets.
Published: (1936)

General considerations on the flow of compressible fluids.
Published: (1936)

Calculation of induced efficiency of heavily loaded propellers having infinite number of blades; Induced efficiency of optimum propellers having finite number of blades; Prospects of propeller drive for high flying speeds.
Published: (1939)

An analysis of the factors that determine the periodic twist of an autogiro rotor blade, with a comparison of predicted and measured results.
Published: (1937)

Propeller tests to determine the effect of number of blades at two typical solidities.
Published: (1939)

Analysis of lateral stability in power-off flight with charts for use in design.
Published: (1936)

Study of two-control operation of airplane.
Published: (1936)

Spinning characteristics of the XN2Y-1 airplane obtained from the spinning balance and compared with results from the spinning tunnel and from flight tests.
Published: (1937)

Longitudinal stability in relation to use of automatic pilot.
Published: (1938)

Estimation of moments of inertia of airplanes from design data.
Published: (1936)

The Design of Propeller Blade Roots.
Published: (1942)

Aerodynamic characteristics of full℗--scale propellers having 2, 3, and 4 blades of Clark Y and R. A. F. 6 airfoil sections.
Published: (1937)

Tests of related forward-camber airfoils in the variable-density wind tunnel.
Published: (1939)

Investigation of lift distribution over the separate wings of biplane.
Published: (1939)

Air flow in the boundary layer near a plate.
Published: (1936)

Wing-nacelle℗--propeller interference for wings of various spans, force, and pressure℗--distribution tests.
Published: (1936)

Fuselage-drag tests in the variable-density wind tunnel : Streamline bodies of revolution, fineness ratio of 5.
Published: (1937)

Pressure distribution over airfoils with Fowler flaps.
Published: (1937)