Cover Image

Photoelastic analysis of 3-dimensional stress systems using scattered light.

Bibliographic Details
Corporate Author:	United States. National Advisory Committee for Aeronautics
Format:	Government Document eBook
Language:	English
Published:	[Washington] : [s.n.], 1939.
Subjects:	Aeronautics. Aeronautics > Research. Specifications.
Online Access:	Electronic resource (PDF)

Similar Items

Blower cooling of finned cylinders.
Published: (1936)

Pressure-distribution measurements on O-2H airplane in flight.
Published: (1936)

Prechamber compression-ignition engine performance.
Published: (1937)

Interference of wing and fuselage from tests of 28 combinations in N. A. C. A. variable℗-density tunnel.
Published: (1936)

Recurrence formula for shear-lag problems.
Published: (1939)

Modern methods of fuel testing.
Published: (1939)

Measurement of the air-flow velocity in the cylinder of an airplane engine.
Published: (1939)

Wind℗-tunnel tests of 10-foot-diameter autogiro rotors.
Published: (1936)

Effect of air℗--passage length on optimum fin spacing for maximum cooling.
Published: (1938)

A study of unsymmetrical-loading conditions.
Published: (1940)

Stability of castering wheels for aircraft landing gears.
Published: (1940)

Flow phenomena on plates and airfoils of short span.
Published: (1936)

Stress concentration around open circular hole in plate subjected to bending normal to plane of plate.
Published: (1939)

Stresses in dive.
Published: (1920)

Stress analysis of beams with shear deformation of the flanges.
Published: (1937)

Wind℗--tunnel tests of 3 lateral-control devices in combination with full℗--span slotted flap on N. A. C. A. 23012 airfoil.
Published: (1938)

Effect of eccentricities on stresses in airplane spars (Airplane Section report).
Published: (1923)

Charts for solution of stresses in airplane wing beams (Airplane Section report).
Published: (1926)

Flight measurements of dynamic longitudinal stability of several airplanes and correlation of measurements with pilots' observations of handling characteristics.
Published: (1936)

Cooling characteristics of 2-row radial engine.
Published: (1935)

Ground-handling forces on a 1/40-scale model of the U. S. airship "Akron".
Published: (1936)

Spinning characteristics of wings I--rectangular cark Y monoplane wing.
Published: (1934)

Aerodynamic characteristics of N. A. C. A. 23012 and 23021 airfoils with 20-percent-chord external-airfoil flaps of N. A. C. A. 23012 section.
Published: (1936)

Full-scale wind-tunnel and flight tests of a Fairchild 22 airplane equipped with external-airfoil flaps.
Published: (1937)

Fatigue testing of wing beams by resonance method.
Published: (1938)

Maximum forces applied by pilots to wheel-type controls.
Published: (1937)

Effect of spark-timing regularity on knock limitations of engine performance.
Published: (1938)

Pressure distribution over airfoil section with flap and tab.
Published: (1936)

Pressure distribution over rectangular airfoil with partial-span split flap.
Published: (1936)

Bibliography of Aeronautics, 1932.
Published: (1936)

Contribution to the problem of airfoils spanning a free jet.
Published: (1936)

Increase in frictional resistance caused by various types of rivet heads as determined by tests of planing surfaces.
Published: (1938)

Flight tests of an airplane showing dependence of the maximum lift coefficient on the test conditions.
Published: (1937)

Performance characteristics of Venturi tubes used in aircraft for operating air-driven gyroscopic instruments.
Published: (1937)

Principles involved in cooling of finned and baffled cylinder.
Published: (1938)

Bibliography of Aeronautics, 1931.
Published: (1935)

Chief characteristics and advantages of tailless airplanes.
Published: (1936)

Experimental investigation of Robinson-type cup anemometer.
Published: (1934)

A study of unsymmetrical-loading conditions.
Published: (1940)

Theory for primary failure of straight centrally loaded columns.
Published: (1936)