Cover Image

Longitudinal stability in relation to use of automatic pilot.

Bibliographic Details
Corporate Author:	United States. National Advisory Committee for Aeronautics
Format:	Government Document eBook
Language:	English
Published:	[Washington] : [s.n.], 1938.
Subjects:	Aeronautics > Research. Airplanes. Aeronautics. Mathematical models.
Online Access:	Electronic resource (PDF)

Similar Items

Flight measurements of dynamic longitudinal stability of several airplanes and correlation of measurements with pilots' observations of handling characteristics.
Published: (1936)

An analysis of longitudinal stability in power-off flight with charts for use in design.
Published: (1935)

Static longitudinal stability and longitudinal control of autogiro rotors.
Published: (1938)

Theory of automatic control of airplanes.
Published: (1939)

Study of two-control operation of airplane.
Published: (1936)

Spinning characteristics of the XN2Y-1 airplane obtained from the spinning balance and compared with results from the spinning tunnel and from flight tests.
Published: (1937)

Maximum forces applied by pilots to wheel-type controls.
Published: (1937)

Torsional stability of aluminum alloy seamless tubing.
Published: (1939)

Generalized analysis of experimental observations in problems of elastic stability.
Published: (1938)

Effect of masses of controls on longitudinal stability with free elevator.
Published: (1939)

Stability of rectangular plates with longitudinal or transverse stiffeners under uniform compression.
Published: (1939)

Performance characteristics of Venturi tubes used in aircraft for operating air-driven gyroscopic instruments.
Published: (1937)

Fatigue testing of wing beams by resonance method.
Published: (1938)

Flight tests of an airplane showing dependence of the maximum lift coefficient on the test conditions.
Published: (1937)

Full-scale wind-tunnel and flight tests of a Fairchild 22 airplane equipped with external-airfoil flaps.
Published: (1937)

A study of unsymmetrical-loading conditions.
Published: (1940)

Chief characteristics and advantages of tailless airplanes.
Published: (1936)

Contribution to the problem of airfoils spanning a free jet.
Published: (1936)

Methods and formulas for calculating the strength of plate and shell constructions as used in airplane design.
Published: (1936)

Theory for primary failure of straight centrally loaded columns.
Published: (1936)

Theoretical study of various airplane motions after initial disturbance.
Published: (1938)

Compression struts with nonprogressively variable moment of inertia.
Published: (1938)

Calculation of load distribution in stiffened cylindrical shells.
Published: (1938)

Study of torque equilibrium of autogiro rotor.
Published: (1938)

Behavior of plate strip under shear and compressive stresses beyond buckling limit.
Published: (1938)

On the determination of the take℗--off characteristics of a seaplane.
Published: (1938)

Behavior of static pressure heads at high speeds.
Published: (1938)

Operational treatment of nonuniform-lift theory in airplane dynamics.
Published: (1938)

Design of centrifugal impeller blades.
Published: (1939)

Ice formation on wings.
Published: (1939)

Potential flow about arbitrary biplane wing sections.
Published: (1935)

Considerations affecting the additional weight required in mass balance of ailerons.
Published: (1937)

Theory of two-dimensional potential flow about arbitrary wing sections.
Published: (1939)

Motion of the two-control airplane in rectilinear flight after initial disturbances with introduction of controls following an exponential law.
Published: (1937)

Comparison of theory with experiment in phenomenom of wing flutter.
Published: (1939)

The impact on floats or hulls during landing as affected by bottom width.
Published: (1936)

Analysis of 3 lowest bending frequencies of rotating propeller.
Published: (1936)

A method of estimating the critical buckling load for structural members.
Published: (1939)

Investigations on the amount of downwash behind rectangular and elliptical wings.
Published: (1936)

Experimental studies of the effective width of buckled sheets.
Published: (1936)