Cover Image

Improvement of aileron effectiveness by prevention of air leakage through hinge gap as determined in flight.

Bibliographic Details
Corporate Author:	United States. National Advisory Committee for Aeronautics
Format:	Government Document eBook
Language:	English
Published:	[Washington] : [s.n.], 1938.
Subjects:	Airplanes. Aeronautics > Research.
Online Access:	Electronic resource (PDF)

Similar Items

Flight comparison of conventional ailerons on rectangular wing and of conventional and floating wing℗--tip ailerons on tapered wing.
Published: (1937)

Reduction of hinge moments of airplane control surfaces by tabs.
Published: (1935)

Calculation of chord-wise load distribution over air℗-foil sections with plain, split, or serially hinged trailing℗--edge flaps.
Published: (1938)

The question of spontaneous wing oscillations (determination of critical velocity through flight-oscillation tests).
Published: (1936)

Wind℗--tunnel and flight tests of slot-lip ailerons.
Published: (1937)

The influence of wing setting on wing load and rotor speed of PCA-2 autogiro as determined in flight.
Published: (1934)

Reduction of aileron operating force by differential linkage.
Published: (1936)

Considerations affecting the additional weight required in mass balance of ailerons.
Published: (1937)

Tests for the determination of the stress condition in tension fields.
Published: (1936)

Method of curved models and its application to the study of curvilinear flight of airships, pt. 2.
Published: (1937)

Method of curved models and its application to the study of curvilinear flight of airships, pt. 1.
Published: (1937)

Investigation of the prevention of ice on the airplane windshield.
Published: (1940)

Propeller tests to determine the effect of number of blades at two typical solidities.
Published: (1939)

Measurement of the air-flow velocity in the cylinder of an airplane engine.
Published: (1939)

A preliminary study of the prevention of ice on aircraft by the use of engine℗--exhaust heat.
Published: (1939)

Airfoil section characteristics as applied to prediction of air forces and their distribution on wings.
Published: (1938)

Tank tests to determine the effects of the chine flare of a flying-boat hull, N. A. C. A. model series 62 and 69.
Published: (1939)

Investigation of full℗--scale split trailing-edge wing flaps with various chords and hinge locations.
Published: (1935)

Full-scale wind℗--tunnel and flight tests of Fairchild 22 airplane equipped with zap flap and zap ailerons.
Published: (1937)

Flight investigation of lateral control characteristics of short wide ailerons and various spoilers with different amounts of wing dihedral.
Published: (1934)

Influence of tip shape on wing load distribution as determined by flight tests.
Published: (1934)

Wing pressure distribution and rotor℗-blade motion of autogiro as determined in flight.
Published: (1933)

Theoretical span loading and moments of tapered wings produced by aileron deflection.
Published: (1937)

Flight tests of an airplane showing dependence of the maximum lift coefficient on the test conditions.
Published: (1937)

N.A.C.A. Stall-warning indicator.
Published: (1938)

Effect of compressibility on 8 full-scale propellers operating in take℗--off and climbing range.
Published: (1938)

Tank tests of model 36 flying-boat hull.
Published: (1938)

Lift distribution of wings with end plates.
Published: (1938)

Pressure distribution over N. A. C. A. 23012 airfoil with slotted and plain flap [National Advisory Committee for Aeronautics].
Published: (1938)

Interference of wing and fuselage from tests of 18 combinations in N. A. C. A. variable-density tunnel combinations with split flap.
Published: (1938)

Approximate stress analysis of multi-stringer beams with shear deformation of flanges.
Published: (1938)

Theoretical stability and control characteristics of wings with various amounts of taper and twist.
Published: (1938)

Preliminary investigation of boundary℗--layer transition along flat plate with adverse pressure gradient.
Published: (1938)

Stresses in reinforcing rings due to axial forces in cylindrical and conical stressed skins.
Published: (1938)

The Dornier wind tunnel.
Published: (1938)

Model experiments on forces and moments acting on end plate fitted to wing.
Published: (1938)

Spinning characteristics of wings : 5, N. A. C. A. 0009, 23018, and 6718 monoplane wings.
Published: (1938)

On some reciprocal relations in theory of nonstationary flows.
Published: (1938)

Crinkling strength and bending strength of round aircraft tubing.
Published: (1938)

Wind℗-tunnel investigation of rectangular and tapered N. A. C. A. 23012 wings with plain ailerons and full℗-span split flaps.
Published: (1938)