Cover Image

The measurement of air speed of airplanes.

Bibliographic Details
Corporate Author:	United States. National Advisory Committee for Aeronautics
Format:	Government Document eBook
Language:	English
Published:	[Washington] : [s.n.], 1937.
Subjects:	Measuring instruments. Airplanes. Aeronautics > Research. Mathematical models.
Online Access:	Electronic resource (PDF)

Similar Items

Theory of automatic control of airplanes.
Published: (1939)

Operational treatment of nonuniform-lift theory in airplane dynamics.
Published: (1938)

Theoretical study of various airplane motions after initial disturbance.
Published: (1938)

Behavior of static pressure heads at high speeds.
Published: (1938)

Methods and formulas for calculating the strength of plate and shell constructions as used in airplane design.
Published: (1936)

Motion of the two-control airplane in rectilinear flight after initial disturbances with introduction of controls following an exponential law.
Published: (1937)

Study of two-control operation of airplane.
Published: (1936)

Measurement of the air-flow velocity in the cylinder of an airplane engine.
Published: (1939)

The critical velocity of a body towed by a cable from an airplane.
Published: (1937)

General airplane performance.
Published: (1937)

Comparative flight and full-scale wind℗--tunnel measurements of the maximum lift of airplane.
Published: (1937)

Working charts for determination of propeller thrust at various air speeds.
Published: (1933)

Measurements and Analysis of the Motion of a Canard Airplane Model in Gusts, Apr. 1940.
Published: (1940)

A simplified application of the method of operators to the calculation of disturbed motions of an airplane.
Published: (1936)

Spinning characteristics of the XN2Y-1 airplane obtained from the spinning balance and compared with results from the spinning tunnel and from flight tests.
Published: (1937)

Estimation of moments of inertia of airplanes from design data.
Published: (1936)

Effect of lateral controls in producing motion of an airplane as computed from wind-tunnel data.
Published: (1936)

Considerations affecting the additional weight required in mass balance of ailerons.
Published: (1937)

Design of centrifugal impeller blades.
Published: (1939)

Ice formation on wings.
Published: (1939)

Potential flow about arbitrary biplane wing sections.
Published: (1935)

Torsional stability of aluminum alloy seamless tubing.
Published: (1939)

Compression struts with nonprogressively variable moment of inertia.
Published: (1938)

Theory of two-dimensional potential flow about arbitrary wing sections.
Published: (1939)

An analysis of longitudinal stability in power-off flight with charts for use in design.
Published: (1935)

Comparison of theory with experiment in phenomenom of wing flutter.
Published: (1939)

Calculation of load distribution in stiffened cylindrical shells.
Published: (1938)

Study of torque equilibrium of autogiro rotor.
Published: (1938)

Behavior of plate strip under shear and compressive stresses beyond buckling limit.
Published: (1938)

The impact on floats or hulls during landing as affected by bottom width.
Published: (1936)

Analysis of 3 lowest bending frequencies of rotating propeller.
Published: (1936)

A method of estimating the critical buckling load for structural members.
Published: (1939)

On the determination of the take℗--off characteristics of a seaplane.
Published: (1938)

Investigations on the amount of downwash behind rectangular and elliptical wings.
Published: (1936)

Experimental studies of the effective width of buckled sheets.
Published: (1936)

General considerations on the flow of compressible fluids.
Published: (1936)

DFS Dive-Control Brakes for Gliders and Airplanes.
Published: (1940)

The Shcok-Absorbing System of the Airplane Landing Gear.
Published: (1940)

The formation of ice on airplanes.
Published: (1936)

Details of the construction and production of fuel pumps and fuel nozzles for the airplane Diesel engine.
Published: (1936)