Potential common cause vulnerabilities in essential service water systems.

Corrosion of valve-to-torque tube keys in spray pond cross connect valves.
Published: (1990)

Microbiologically influenced corrosion of emergency diesel generator service water piping.
Published: (1994)

Water chemistry and corrosion of nuclear power plant structural materials /
by: Kritsky, V. G.
Published: (1999)

Excessive temperatures in emergency core cooling system piping located outside containment.
Published: (1989)

Effect of a DC power supply failure on ECCS performances.
Published: (1980)

Westinghouse ECCS evaluation models.
Published: (1986)

Microbiologically induced corrosion of containment service water system.
Published: (1985)

High-energy piping failures caused by wall thinning.
Published: (1991)

Potential for stress corrosion cracking in steam generator tube plugs supplied by Babcock and Wilcox.
Published: (1989)

Design deficiencies can lead to reduced ECCS pump net positive suction head during design-basis accidents.
Published: (1998)

Failure to close service water cross-connect isolation valves.
Published: (1989)

Potential for water hammer, thermal stratification, and steam binding in high-pressure coolant Injection piping.
Published: (1989)

Erosion-corrosion of PWR feedwater piping survey of experience, design, water chemistry, and materials /
by: Jonas, Otakar
Published: (1988)

Proceedings of the International Symposium on Environmental Degradation of Materials in Nuclear Power Systems--Water Reactors : Myrtle Beach, South Carolina, August 22-25, 1983 /
Published: (1984)

Failure of condensate piping because of erosion-corrosion at a flow-straightening device.
Published: (1995)

Rupture in extraction steam piping as a result of flow-accelerated corrosion.
Published: (1997)

Managing gas accumulation in emergency core cooling, decay heat removal, and containment spray systems.
Published: (2008)

Fire protection system design deficiencies and common-mode flooding of emergency core cooling system rooms at Washington Nuclear Project Unit 2.
Published: (1998)

Valve stem corrosion failures.
Published: (1985)

RHR valve misalignment causes degradation of ECCS in PWRS.
Published: (1987)

Defective RHR replacement piping.
Published: (1984)

Suceptibility of low-pressure coolant injection and core spray injection valves to pressure locking.
Published: (1995)

Reduction of reactor coolant inventory because of misalignment of RHR valves.
Published: (1986)

Thermally induced pressure locking of a high pressure coolant injection valve.
Published: (1996)

15th International Conference on Environmental Degradation of Materials in Nuclear Power Systems--Water Reactors : proceedings of the 15th International Conference on Environmental Degradation of Materials in Nuclear Power Systems-- Water Reactors ; held August 7-11, 2011 at the Cheyenne Mountain Resort, Colorado Springs, Colorado /
Published: (2011)

Valve body erosion.
Published: (1989)

Corrosion of William Powell gate valve disc holders.
Published: (1994)

Foreign material found in the emergency core cooling system.
Published: (2006)

Knowledge base for the effect of debris on pressurized water reactor emergency core cooling sump performance /
Published: (2003)

Intergranular stress corrosion cracking leading to steam generator tube failure.
Published: (1984)

IGSCC in BWR plants.
Published: (1984)

Stress corrosion cracking in PWR steam generator tubes.
Published: (1990)

ECCS calculations on fuel cladding.
Published: (1979)

Report on ECCS cladding models, NUREG-0630.
Published: (1980)

HPCI/RCIC high steam flow setpoints.
Published: (1982)

Safety aspects of the Yankee Rowe Nuclear Powerplant : oversight hearing before the Subcommittee on Energy and the Environment of the Committee on Interior and Insular Affairs, House of Representatives, One Hundred Second Congress, first session ... hearing held in Washington, DC, August 1, 1991.
Published: (1992)