Derivation of the data reduction equations for the calibration of the six-component thrust stand in the CE-22 advanced nozzle test facility /

A performance comparison of two small rocket nozzles /
by: Arrington, Lynn A., et al.
Published: (1996)

A data acquisition and control program for axial-torsional fatigue testing /
by: Kalluri, Sreeramesh
Published: (1989)

A data acquisition and control program for axial-torsional fatigue testing /
by: Kalluri, Sreeramesh
Published: (1989)

Buckling test results from the 8-foot-diameter orthogrid-stiffened cylinder test article TA01 : test dates: 19-21 November 2008 /
by: Hilburger, Mark W. (Mark William), et al.
Published: (2015)

An investigation at static conditions of nonaxisymmetric nozzle thrust reverser port geometry including effects of rounding and rotating the port corner /
by: Arbiter, Dorothy G.
Published: (1985)

Analysis and design of optimized truncated scarfed nozzles subject to external flow effects /
by: Shyne, Rickey J.
Published: (1990)

Measured pressure distributions inside nonaxisymmetric nozzles with partially deployed thrust reversers /
by: Green, Robert S.
Published: (1987)

Static internal performance of a two-dimensional convergent nozzle with thrust-vectoring capability up to 60 ̊ /
by: Leavitt, Laurence D.
Published: (1985)

Static internal performance of single -expansion-ramp nozzles with thrust-vectoring capability up to 60° /
by: Berrier, Bobby L., et al.
Published: (1984)

Separate flow nozzle test status meeting : proceedings of a conference held at and sponsored by NASA Glenn Research Center, Cleveland, Ohio, September 9-10, 1997 /
Published: (2000)

Effects of sidewall geometry on the installed performance of nonaxisymmetric convergent-divergent exhaust nozzles /
by: Yetter, Jeffery A., et al.
Published: (1980)

Preliminary nonlinear structural analysis of advanced composite tow-steered shells with large geometric imperfections /
by: Dobrin, Calvin P., et al.
Published: (2019)

Flow processes in overexpanded chemical rocket nozzles.
by: Schmucker, Robert H.
Published: (1984)

Axial and torsional fatigue behavior of Waspaloy /
by: Zamrik, S. Y., 1932-
Published: (1986)

Investigation of low-Reynolds-number rocket nozzle design using PNS-based optimization procedure /
by: Hussaini, M. Moin, et al.
Published: (1996)

Vacuum chamber pressure effects on thrust measurements of low Reynolds number nozzles /
Published: (1985)

Static performance of a fixed-geometry exhaust nozzle incorporating porous cavities for shock-boundary layer interaction control /
by: Asbury, Scott C., et al.
Published: (1999)

Exhaust nozzle plume effects on sonic boom test results for isolated nozzles /
by: Castner, Raymond S.
Published: (2011)

Effects of nozzle exit geometry and pressure ratio on plume shape for nozzles exhausting into quiescent air /
by: Scallion, W. I.
Published: (1991)

Aeropropulsive characteristics of isolated combined turbojet/ramjet nozzles at Mach numbers from 0 to 1.20 /
by: Carson, George T., et al.
Published: (1988)

Uncertainty analysis of the CE-22 advanced nozzle test facility /
by: Hubbard, Erin P.
Published: (2019)

Forced response testing of anaxi-centrifugal turboshaft engine /
by: Owen, A. Karl
Published: (1996)

Methodology for three dimensional nozzle design /
by: Ferri, Aldo A., et al.
Published: (1974)

Proposed flight research of a dual-bell rocket nozzle using the NASA F-15 airplane /
by: Jones, Daniel S., et al.
Published: (2013)

Investigation of convergent-divergent nozzles applicable to reduced-power supersonic cruise aircraft /
by: Berrier, Bobby L., et al.
Published: (1980)

Converging-diverging nozzle thruster code for nuclear or chemical rocket performance computations /
by: Juhasz, Albert J.
Published: (2019)

Jet noise reduction potential from emerging variable cycle technologies /
by: Henderson, Brenda S., et al.
Published: (2012)

Decomposing solid micropropulsion nozzle performance issues /
by: Reed, Brian D.
Published: (2003)

Noise from aft deck exhaust nozzles : differences in experimental embodiments /
by: Bridges, James E.
Published: (2014)

Operating characteristics of the multiple critical venturi system and secondary calibration nozzles used for weight-flow measurements in the Langley 16-foot transonic tunnel /
by: Berrier, Bobby L.
Published: (1985)

Experimental evaluation of a translating nozzle sidewall radial turbine /
by: Roelke, Richard J.
Published: (1987)

Shelf life extension for the lot AAE nozzle severance LSCs : final test report /
by: Cook, M.
Published: (1990)

An Approximate solution and master curves for buckling of symmetrically laminated composite cylinders /
by: Nemeth, Michael P.
Published: (2013)

Evaluation of the behavior of Technova Corporation rod-stiffened stitched compression specimens /
by: Dawn C. Jegley
Published: (2013)

Theoretical study on the effect of the design of small (milli-newton) thruster jets on molecular contamination for the space station /
by: Riley, Ben R.
Published: (1986)

Bearing-load modeling and analysis study for mechanically connected structures /
by: Knight, Norman F.
Published: (2006)