The generation and classification of mixed strategy sampling plans.

Plan generation strategies for a knowledge based process planning system /
by: Hari, Umesh
Published: (1993)

An economic basis with inspector accuracy considerations for design of a multi-level continuous sampling plan.
by: Elliff, Gerald Allen
Published: (1973)

Dependent state attribute acceptance sampling.
by: Mogg, Jackie Melvin
Published: (1969)

Analysis of clerical operation by application of work sampling.
by: Springer, Joy Victor
Published: (1954)

Dependent-deferred state attribute acceptance sampling.
by: Baker, Revenor Cornelius
Published: (1971)

Bill of material generator.
by: Brooking, Stanley Anderson
Published: (1970)

Turbulent mixing in ducts, theory and experiment application to aerosol single point sampling /
by: Langari, Abdolreza, 1968-
Published: (1997)

An introduction to price-adjusted single sampling with quadratic indifference.
by: Jacobi, John Albert
Published: (1970)

A study on the effect of inlet turbulence on gas mixing for single point aerosol sampling /
by: Mohan, Anand
Published: (2001)

Evaluation of mixing downstream of tees in duct systems with respect to single point representative air sampling /
by: Kim, Taehong, 1973-
Published: (2003)

Solving mixed 0-1 knapsack problems using Fenchel cutting planes /
by: Yan, Xiao-Qing
Published: (1995)

A comparison of the regular interval, varying start technique of work sampling with the completely random technique.
by: Poage, Scott Tabor
Published: (1957)

A methodology for generation of a 3-dimensional facility model /
by: Chawla, Ravi, 1975-
Published: (2001)

Using mixed integer programming to schedule experiments on the Texas A&M University nuclear science center reactor /
by: Drees, Lawrence David, 1969-
Published: (1999)

Electrostatic charge generation during impeller mixing in two-phase systems /
by: Hernandez, Andrew, 1963-
Published: (1988)

Determination of corporate objectives and evaluation of alternative strategies through the use of simulation models.
by: Beals, Robert Patterson
Published: (1970)

A study of the mixing viscosity of asphalt in hot-mix production.
by: Khan, Md. Musharraf Hossain
Published: (1961)

Optimal burn-in strategy of gate oxide based on yield and reliability /
by: Kim, Taeho, 1960-
Published: (1998)

Process planning : a formal modeling approach with an interface architecture for shop floor control /
by: Lee, Seongkyu, 1961-
Published: (1994)

Strategies for multiple response robust quality engineering using desirability functions /
by: Hwang, Inkeuk, 1959-
Published: (1996)

Evaluation of mixing in three duct configurations and development of a Generic Tee Plenum System (GTPS) for application to single point aerosol sampling /
by: Han, Tae Won, 1970-
Published: (2003)

A mixed integer linear programming approach for obtaining an optimal signal timing plan in general traffic networks.
by: Chaudhary, Nadeem Ahmad
Published: (1987)

Analysis of a small sample geometry for concurrent identification and quantification of mixed-nuclide samples /
by: Krieger, Kenneth Vincent, 1964-
Published: (1999)

A methodology for generating distribution system pumping schedules in the presence of maximum demand charges and multiple pressure zones /
by: Jamieson, Richard Andrew
Published: (1995)

Use of decision analysis in corporate planning.
by: Siddiqui, Mohammed Ashfaq
Published: (1972)

Network planning based on the gamma distribution.
by: Jones, Hubert Chapman
Published: (1969)

Intelligent support for template based planning /
by: Erraguntla, Madhav
Published: (1996)

An optimization procedure for network planning systems.
by: Madrigal, Orlando Sia
Published: (1967)

An algorithm for optimal water resources planning.
by: Raju, Indukuri Venkata Satyanarayana
Published: (1968)

A stochastic mixed integer programming approach to wildfire management systems /
by: Lee, Won Ju
Published: (2010)

Evaluation of detector placement strategies for first generation traffic responsive signal control /
by: Brehmer, Christopher Lynn, 1974-
Published: (1996)

Automatic defect classification of printed wiring board solder joints /
by: Nolan, Daniel J., 1964-
Published: (1989)

Analysis of an imperfectly mixed distillation tray according to the eddy diffusion and finite cell models.
by: Roemer, Milton Harry
Published: (1964)

A branch-and-bound project assignment methodology with generalized network strategies for updating bounds /
by: Jittamai, Phongchai, 1973-
Published: (1999)

A generalized simulation model for corporate planning.
by: Viswanathan, Krishnan
Published: (1972)

Procedures for the development of urban water planning objectives.
by: Thornton, Billy Max
Published: (1972)