The use of elastomeric pads as bearings for steel beams.

An analysis procedure to facilitate performance-based design of steel moment frame buildings with reduced beam section joints /
by: Jones, Scott Laurence
Published: (2000)

Elastomeric bridge bearings : recommended test methods /
Published: (2001)

Analysis of elastomeric bridge bearings /
by: Hamzeh, O.
Published: (1995)

Behavior of Hot Rolled Asymmetric Steel I-Beams: Concept to Construction /
by: Stoddard, Eric Alan
Published: (2023)

An energy balance method of fracture prediction in elastomers and elastomeric composites.
by: Webb, Leonard Dale
Published: (1969)

The effect of temperature on the bending of laminated glass beams /
by: Edel, Matthew Thomas, 1973-
Published: (1997)

A beam-column method for tieback walls /
by: Kim, Nak-Kyung, 1962-
Published: (1994)

An Investigation of the Stresses in Uniformly Loaded Continuous Deep Beams.
by: Shubinski, Robert Parker
Published: (1960)

Numerical analysis of slender beams under dynamic loads.
by: McMickle, Ralph Wayne
Published: (1968)

The time-dependent deflections of prestressed concrete bridge beams.
by: Sinno, Raouf
Published: (1968)

Behavior of prestressed composite T-beams of lightweight aggregate concrete.
by: Hasnat, Abul
Published: (1965)

Elastomeric bearings design, construction, and materials /
by: Stanton, J. F. (John F.)
Published: (1982)

Test methods for elastomeric bearings on bridges /
by: Arditzoglou, Y. J.
Published: (1995)

Investigation of the Helix-Grooved Elastomeric Pump /
by: Jacobsen, Kelly Scott
Published: (1982)

An investigation of the nature of microstructural damage in a filled elastomeric compostie material.
by: Elliott, David Meacham
Published: (1968)

Diagonal tension resistance of structural lightweight aggregate concrete beams.
by: Rashid, Kazi Harun-Ur-
Published: (1966)

Matrix analysis of beams on discrete, non-linear elastic supports.
by: Cheng, Aylmer Pao-Sheng
Published: (1967)

Elastomerics.

An investigation of the ultimate flexural capacity of reinforced lightweight aggregate concrete beams.
by: Bridges, James W.
Published: (1961)

Thermoelastohydrodynamic tilt pad journal bearing simulation and application to rotor-bearing model /
by: Kim, Jinsang, 1960-
Published: (1993)

Effect of column-to-beam strength ratio on earthquake resistance of RC moment frames using probabilistic performance-based design methodologies /
by: Dooley, Kara Lenee, 1977
Published: (2001)

Measurements of static loading characteristics of a Flexurepivot Tilt Pad Hydrodynamic Bearing /
by: Walton, Nicholas Van Edward, 1970-
Published: (1995)

Tests of concrete beams with externally-bonded glass-fiber fabric web reinforcement /
by: Dabholkar, Niranjan Shamsunder
Published: (1999)

Wave equation prediction of pile bearing capacity.
by: Bartoskewitz, Richard Edward
Published: (1970)

In-situ measurement of skin friction and point bearing.
by: Rehmet, Joseph Don
Published: (1970)

The effective resistance of structural steel beams to combined flexural and torsional loads.
by: Yantis, Charles Weldon
Published: (1963)

Measured and predicted rotordynamic coefficients and static performance of a rocker-pivot tilt pad bearing in load-on-pad and load-between-pad configurations /
by: Carter, Clint Ryan
Published: (2010)

Skin friction for steel piles in sand.
by: Sulaiman, Ibrahim Hikmat
Published: (1967)

A Computational Model for Tilting Journal Bearings with Pad Flexibility /
by: Li, Yingkun
Published: (2015)

Abnormal and eccentric forces on elastomeric bridge bearings.
by: Price, A. R.
Published: (1976)

Full-Scale Floor System Testing for Future Hot-Rolled Asymmetric Steel I-Beams /
by: Davis, Sheyenne
Published: (2023)

Connection of modular steel beam precast slab units with cast-in-place closure pour slabs /
by: Brush, Natalie Camille, 1980-
Published: (2005)

Design of a 233', 10'' center bearing swing bridge.
by: Crockett, James B.
Published: (1909)

In-situ measurements of friction and bearing correlated with instrumented pile tests.
by: Perdue, George William
Published: (1970)

Seismic isolation of nuclear power plants using elastomeric bearings /
by: Kumar, M., et al.
Published: (2019)

Fatigue analysis of stringer to floor beam connections in through plate girder and through truss railroad bridges /
by: Evans, Leslie Virginia, 1974-
Published: (1999)